Yale SmartHome Alarm series Spécifications télécharger pdf (Page 22)

Changing the Batteries

Control unit low battery

Indication

The control unit will display all device low battery

conditions with the exception of the siren. This is

shown by a fault display with the fault LED lit on the

front panel. In addition the devices also can show

low battery conditions as described below. When a

device ﬁrst shows low battery signal it has enough

battery capacity to operate for a further month

before complete exhaustion.

Siren battery change

When the batteries start getting low the siren will

produce a series of pips and ﬂashes during arming

and disarming.

1 Switch off tamper protection at the control unit as

described in the end of section 6.

2 Remove the siren lid and switch the siren power

switch to OFF.

3 Unscrew the four screws on the battery

compartment lid and remove the cover.

4 Remove the four batteries, wait for 30 seconds,

and replace them with four fresh alkaline “D” cells.

5 Switch on siren power and check that the siren

beeps and ﬂashes.

Warning: After the batteries have been inserted, the

tamper will become active after three hours. Please

replace the cover back onto the siren quickly.

6 Replace battery compartment lid and screws and

reattach siren lid. Siren tamper protection will be

automatically enabled after 3 hours.

•Sirencasetamperconditionsarealsosignalled

by a series of beeps when the system is armed

but not when the system is disarmed (low battery

warning produces a series of pips when armed

and disarmed), take care not to confuse the two

different conditions.

PIR battery change

When the battery is low the LED will ﬂash when any

movement is detected. The batteries are changed as

follows:

1 Put control unit into programming mode to prevent

a tamper alarm.

2 Loosen the case screw and remove PIR sensor

from base to reveal three AAA batteries.

3 Insert new alkaline batteries observing correct

polarity. The PIR LED will ﬂash for 30 seconds

while initialising.

4 Reﬁt sensor on base and tighten bottom case

screw. Switch tamper protection back on.

•PIRcasetamperconditionsarealsoindicatedby

a ﬂashing LED, check the tamper before changing

the batteries.

Door/Window Sensor battery change

When the battery is low the LED will light up when

the door/window is opened. The battery is changed

as follows:

1 Put control unit into programming mode to prevent

a tamper alarm.

2 Loosen the case screw and remove door/window

sensor from base to reveal battery.

3 Using a screwdriver gently lever out the old

battery.

4 Insert new CR2032 coin cell with the + side

uppermost.

5 Press battery into holder ﬁrmly with ﬁnger and

thumb until a click is heard.

6 Reﬁt sensor on base and tighten bottom case

screw. Switch tamper protection back on.

•Door/windowsensorcasetamperconditions

are also indicated by a lit LED, check the tamper

before changing the battery.

Always use alkaline batteries or the correct type of coin cells as replacements because any

other battery can cause problems with the operation of the system. Typical life of batteries

is two years or more. Ensure the correct steps are taken when changing batteries in tamper

protected devices.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Yale SmartHome Alarm series Spécifications Page 22

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Yale SmartHome Alarm series